Hi
I am using 1.24 BETA 15A and have problems with direct config.
When trying to read BCM in direct config, "Seed key not correct" error appears as in picture and no data from BCM module is read.
Also I am trying to enable Frost warning LED and Auto Start/Stop LED inside IPC gauges (as a default, I have these two indicators in my IPC LCD display as in picture).
Reading IPC direct config shows that both these LEDs are enabled which is not true. Disabling and then re-enabling did not help
Please give your feedback on these issues. Thanks!
Issues with Direct config
Модератор: DanMc85
-
- Сообщения: 22
- Зарегистрирован: 21 ноя 2014, 14:01
Issues with Direct config
У вас нет необходимых прав для просмотра вложений в этом сообщении.
- kroligoff
- Сообщения: 1498
- Зарегистрирован: 16 янв 2013, 11:38
Re: Issues with Direct config
Please Give me more Informatrion VIN (IN PM)
-
- Сообщения: 22
- Зарегистрирован: 21 ноя 2014, 14:01
Re: Issues with Direct config
Thanks for responding, provided VIN in PM...please check
- kroligoff
- Сообщения: 1498
- Зарегистрирован: 16 янв 2013, 11:38
Re: Issues with Direct config
Please try B15B and BCM (DV6T)
And try IPC
And try IPC
-
- Сообщения: 22
- Зарегистрирован: 21 ноя 2014, 14:01
Re: Issues with Direct config
Thanks! Beta15B does the trick...BCM DV6T now reads the configuration
However, IPC issues are still the same. The Frost and Auto Start/Stop indicators appear in the LCD display rather than as LED indicators inside the gauges.
However, IPC issues are still the same. The Frost and Auto Start/Stop indicators appear in the LCD display rather than as LED indicators inside the gauges.
- kroligoff
- Сообщения: 1498
- Зарегистрирован: 16 янв 2013, 11:38
Re: Issues with Direct config
You IPC Have Last SW version?
-
- Сообщения: 22
- Зарегистрирован: 21 ноя 2014, 14:01
Re: Issues with Direct config
Yes
У вас нет необходимых прав для просмотра вложений в этом сообщении.