UCDS Forum

UCDS 2.0.003.001
Mondeo (Euro) [CD391] - 2015>
ABS-Module update

Update Wizard lists as newest: EG9C-2D053-BJ with IDS calibration level EG9C-2C219-BJ
Update Wizard loads only Bootloader and EG9C-2D053-BJ - no calibration file
After update ABS and ESC not working - requiring service
ABS diagnostic trouble code: no calibration

I was not able to download a calibration file EG9C-2C219-BJ for manual loading with VBF-File-Loader to fix the problem.
Maybe there is no such download required and a service routine (re-)creates this calibration file?
Any ideas to solve the problem?
If the update requires afterwards a service routine I would recommend a hint in this respect before updating instead of
the rather unspecific Warning which is given.

Cruiser писал(а):UCDS 2.0.003.001
Mondeo (Euro) [CD391] - 2015>
ABS-Module update

Update Wizard lists as newest: EG9C-2D053-BJ with IDS calibration level EG9C-2C219-BJ
Update Wizard loads only Bootloader and EG9C-2D053-BJ - no calibration file
After update ABS and ESC not working - requiring service
ABS diagnostic trouble code: no calibration

I was not able to download a calibration file EG9C-2C219-BJ for manual loading with VBF-File-Loader to fix the problem.
Maybe there is no such download required and a service routine (re-)creates this calibration file?
Any ideas to solve the problem?
If the update requires afterwards a service routine I would recommend a hint in this respect before updating instead of
the rather unspecific Warning which is given.

Try using VBF Loader on HS2 to flash manually
Same SBL as before

then these two files
EG9C-2D053-BJ.vbf
EG9C-14C602-BK.vbf

You may have to do an IVD initialization and a EPB maintenance mode on the ABS for service procedures.

Thanks a lot DanMc85,

the EG9C-14C602-BK.vbf-file made all the difference.

There was so far no system call to do an IVD initialization and a EPB maintenance mode on the ABS for service procedures and I am happy about that as I was not able to figure out what an IVD init. is and how to initiate it.

Anyway the system is up again and running.