Страница 1 из 1

help retrofit to convers+

Добавлено: 13 апр 2018, 14:40
koster
У меня есть Ford Mondeo 2008 Я хочу сменить приборную панель автомобиля, теперь она с моделью 6M2T 10849 CP, и я хочу заменить ее этой моделью AM2T 10849 VC, которая CONVERS +, но, разместив ее и постоянно зажечь аэрограф и запустив ошибки в компьютере автомобиля, поможет, если вы знаете, как я могу справиться с этим очень сильно. Я хочу поставить свою новую панель усиления на автомобиль

Re: help retrofit to convers+

Добавлено: 14 апр 2018, 08:57
kroligoff
Please write on russian, on russian i do not understand

Re: help retrofit to convers+

Добавлено: 14 апр 2018, 23:04
koster
I have a Ford Mondeo 2008 I want to change the instrument panel of the car now with a model 6M2T 10849 CP and I want to replace it with this model AM2T 10849 VC but by putting it on and flashing an airbrush and starting to make mistakes in the computer of the car help how can to fix a lot I want to put my new instrument panel on the car

Re: help retrofit to convers+

Добавлено: 16 апр 2018, 18:06
kroligoff
Need install special firmware "Motral Convers+" and choose "installed on older car"
Motral.png

Re: help retrofit to convers+

Добавлено: 16 апр 2018, 18:19
koster
where to download this file and what kind of program I need to upload it and can you upload with elm327 cable

Re: help retrofit to convers+

Добавлено: 17 апр 2018, 20:00
zaqik
kroligoff писал(а):Need install special firmware "Motral Convers+" and choose "installed on older car"
in my opinion not ... AM2T 10849 VC is between prefacelift and facelift (fw version 11xx) ... you cannot upload 14xx into it

Re: help retrofit to convers+

Добавлено: 17 апр 2018, 20:01
zaqik
koster писал(а):where to download this file and what kind of program I need to upload it and can you upload with elm327 cable
free sw for upload does not exist

Re: help retrofit to convers+

Добавлено: 17 апр 2018, 20:06
koster
and is there how to restart CONVERS+
because I put it now CONVERS+ in my car lights an airbag and does not go out

Re: help retrofit to convers+

Добавлено: 17 апр 2018, 20:54
Artist
To change the firmware in IPC (convers +) via elm, try:

:arrow: • conversmod •

Re: help retrofit to convers+

Добавлено: 17 апр 2018, 23:09
zaqik
it is not solution for user koster :roll: