UCDS Forum

I changed the BCM from a different car, to get some more functions available.
it was possible to flash the firmware what i need with UCDS
I get every function I need running, but one error don't go away. the interior dome light flashing! the BCM DTC is

U2100 Initial Configuration not complete
Ext.Status: 04 Minimum Adaption Limit not reached. (DTC) Pressent at Time of request
00- Error Status not found in base

If I remove the factory BCM back to the car, I get the same error, but its possible to fix that with IDS using module installing function. IDS initialize the BCM in the system and everything is good.
If I try to do the same with the different BCM, IDS say me can not found hardware number and stop programming.

do have someone a idea, how to get the BCM full initialized to the car? to get away the domelight flashing?

Tahnk you

You vehicle?

2016 Mustang

Iknow this sound stupid :but have you tried to program tire preasure into the car because mondeo smax galaxy blinks with dome ligth when bcm had been updated and it is first disapearring when tirepresure is relearnt
i think that they share alot of the same modules
rgds sev

I thought the same, also because I had a problem to learn the tire pressure. but for start I disabled it and the TPMS was not longer an issue.