UCDS Forum

Hello, try to update bcm, update went thru no problem. But after it finished i cant turn ignition on.

your VIN?

1FM5K8GT8GGA49880

no info about modules in etis
do you have printscreen from update wizard?

From etis

try in VBF loader (explorer U502):
SBL DG9T-14C187-AB
file GU5T-14C184-AAG

Thankyou. In vbf loader(for dead modules) i put my bcm part number from etis and programm found (sbl). Then i download software file and loaded. Programming ok. Bcm good. Thank for pointing me to the rigjt direction . But i still have an errors , configuration not complete, my keyless dosn't work. I download and load as-build, didnt help.

Direct configuration - Explorer - BCM - read from module ... configuration DE00-DE3E is filled? and other fields?

and DTC from BCM?

I'm going away for 3 days, will check this on monday. Thankyou

all the fields are filled, only keyless dont work and one error.

try "download as-built from etis" and "write to module"

hello i did loaded as-build from etis but it didn help. may be i need to load more files to bcm, i loaded DG9T-14C187-AB, GU5T-14C184-AAG , needs a calibration files too.

hello to all. problem solved. i found my first scan in ucds sessions with all calibration part numbers download them from motorcraftservices and put them in right order like in a scan in vbf loader and programm them. now everething works. look at my picture on a scan cal files they are in right order, but update wizard put cal files in different order part4 part3 part5 part2 part6. maybe that was my problem? special thanks to Zagik.

Possible the devs correct this, so the files come in correct order?

pyatka писал(а):From etis

Dear, could you give me web site where i can find information obout modul from my VIN???