UCDS Forum

Hi
I have a problem with the configuration of PAM in ford fusion 2015 SE .I have installed 6 pdc(parking sensors)in The front of my bumper ,on The back i have got 4 oryginal pdc sensors.I can only activate 4+4=8 (front +rear) i have tried activate 6+4=10 (6 front +4 rear),unfortunately it doesn't work
It always ends with a message "block writing failed - incompatible configuration." . My VIN 3FA6P0HD0FR179992 My PAM
F10A - ECU Cal-Config Part Number : PAM-Default Config -4/8ch
F110 - On-line Diagnostic Database Reference Number : DS-DG9T-15K866-CL
F111 - ECU Core Assembly Number : DG9T-14F159-DA
F113 - ECU Delivery Assembly Number : DG9T -15K866-FF
F162 - Software Download Specification Version : 0x05
F163 - Diagnostic Specification Version : : 0x03
F188 - Vehicle Manufacturer ECU Software Number : DG9T -14C090-FF
F18C - ECU Serial Number : CD4_XS256_12


What to do to run all mounted PDCs?

I need to replace the BCM module? Is this a software problem, what files should I use?

Programmatically, nothing can be done. I am planning to replace the BCM module, now it is FG9T-15604-CG on EG9T-15604-BL. Will all 12 PDC sensors work on this module?