UCDS Forum

Hello all

I am really frustrated about this

The car is a 2010 Mondeo MK4 2.0 TDCi with the DW10C engine (one of the first with this engine.)

I have changes CCC via asbuilt, then I use the function "allow central configuration Data Parameter (CDP) Learning. (It says completede in 2 seconds)

Then i reset all adaptations.

BUT, the result is not there. The torque drop off is at 2800rpm, not 3400 as it should be with the 163 fuel map.

What can I do?

Regards Tommy

If i try the CCC learning, under the PCM reprogramming tab, i can se UCDS connect to the PCM, and but then it says Error:Invalid key (0x35)

On this calibration you can not change map to 163 BHP.

You must update PCM to e.g. BG91-14C204-BP