UCDS Forum

Hi

I am using 1.24 BETA 15A and have problems with direct config.
When trying to read BCM in direct config, "Seed key not correct" error appears as in picture and no data from BCM module is read. Also I am trying to enable Frost warning LED and Auto Start/Stop LED inside IPC gauges (as a default, I have these two indicators in my IPC LCD display as in picture). Reading IPC direct config shows that both these LEDs are enabled which is not true. Disabling and then re-enabling did not help


Please give your feedback on these issues. Thanks!

Please Give me more Informatrion VIN (IN PM)

Thanks for responding, provided VIN in PM...please check

Please try B15B and BCM (DV6T)
And try IPC

Thanks! Beta15B does the trick...BCM DV6T now reads the configuration

However, IPC issues are still the same. The Frost and Auto Start/Stop indicators appear in the LCD display rather than as LED indicators inside the gauges.

You IPC Have Last SW version?

Yes