UCDS Forum

Hello Guys, need help.
My Girlfriend is killig me Right now haha. She has a 2018 Ford Fiesta 1.0 Ecoboost Manual with 100HP and i wanted to do the 125hp Calibration. I checked UCSS Wiki and i saw okay thats SBL and Calibration for 125. Flashed and the PCM gone. Afterwards i checked the PCM Partsnumber and its totaly different…

Car Spec:
Ford Fiesta 1.0 EcoBoost Manual 100 Hp 2018
P/N: H1B1-12A650-FA
H/W: HA6A-12B684-PA

Then i flashed first with the
Partno: J1B1-12A650-Rx
SBL: HA6A-14C273-DA
Firmware: J1B1-14C204-RK (wrong PCM)

After flashing the PCM is dead.
Then i Flashed again with Force Flashing for Dead Modules.
Partno: H1B1-12A650-Mx
SBL: HA6A-14C273-DA
Firmware: H1B1-14C204-ML

Again no symptons on PCM.
Did i fucked up the whole PCM or did i just flashed with the Wrong sbl and Calibration?
Can someone help me fast?

vin no ?

Found at found dealer calibrationname and did a reflash. Now everythings runs fine.

But is it possible to do the 125hp calibration?