BCM mondeo mk5/smax mk2

[maniek111]

Hello, I have two BCMs at home, one from a Mondeo and the other from a SMAX MK2. I'm trying to run them on a bench at home to read and configure them. I managed to read the configuration and change the software, but I can't change anything in the module configuration.
Power + J2 pins 37 and 38, J8, J7 pin 17, ground - J3 pins 6, 7, and 10, CAN L J7 pin 9, CAN H J7 pin 10.
How do I bridge the ignition switch so that the ignition allows the changes to be saved to the module?
My BCMs:
Mondeo MK5 - FU5T-15604-CAL
SMAX MK2 - GU5T-15604-CFC.