UCDS Forum

i found the PAM update for audio over speakers on WIKI - but not sure if it will work with my module?

I checked the roll back files and they don't match my current module and i cannot download the current ones for my car (Vehicle Mfr ECU SW fails to download).
I am also unsure how to use the VBF loader for them - i can see which module is the SBL, but does it matter which order the other two files are and how do i tell?

My Current Module is:
p/n/calibration level 8G92-15K866-AA
Current/Update version 8G92-14C090-AA

VIN WF0EXXGBBE9G43288

Can anyone help?

BS7T-14C090-AC is for facelift ... in my opinion this fw cannot be uploaded into your PAM

warning: facelift PAM is for front+rear sensors (not for rear only)

Thanks for the reply.

I thought the restore firmware was no good - but the files to put audio through the speakers is 7G92 - which i would think would work? I've got motral's 1122 custom firmware installed on a PreFL dash and have a sony 6CD DAB stereo.

I'm happy to try it but i will need the right firmware to roll back if it doesn't work?