UCDS Forum

I have updated the IPC with the UpdateWizard, now I have the error code "DTC Error read - IPC
DTC Errors: 1

U2100 - Initial Configuration Not Complete
Ext.Status: 0A - Minimum Adaption Limit Not Reached. (DTC) Present at Time of Request.
00- Error status not found in base ....

The update went through without error messages.
If I try now on the old state back again comes the message that I must download the file GJ5T-14C016-BK. Unfortunately, this does not work because the file is missing.

What can I do now to get the error away?

I'm grateful for every tip.

Thomas

Here I attach a few screenshots.

silvercircle писал(а):I have updated the IPC with the UpdateWizard, now I have the error code "DTC Error read - IPC
DTC Errors: 1

U2100 - Initial Configuration Not Complete
Ext.Status: 0A - Minimum Adaption Limit Not Reached. (DTC) Present at Time of Request.
00- Error status not found in base ....

The update went through without error messages.
If I try now on the old state back again comes the message that I must download the file GJ5T-14C016-BK. Unfortunately, this does not work because the file is missing.

What can I do now to get the error away?

I'm grateful for every tip.

Thomas

Here I attach a few screenshots.

In Direct Config... Reload the entire As-Built to the module... Do a load from ETIS and then write to module... should clear the DTC.

This is the current state of the files causing the error

Thank you, it has worked fine, no errors and the modul answerd.

DanMc85 писал(а):

silvercircle писал(а):I have updated the IPC with the UpdateWizard, now I have the error code "DTC Error read - IPC
DTC Errors: 1

U2100 - Initial Configuration Not Complete
Ext.Status: 0A - Minimum Adaption Limit Not Reached. (DTC) Present at Time of Request.
00- Error status not found in base ....

The update went through without error messages.
If I try now on the old state back again comes the message that I must download the file GJ5T-14C016-BK. Unfortunately, this does not work because the file is missing.

What can I do now to get the error away?

I'm grateful for every tip.

Thomas

Here I attach a few screenshots.

In Direct Config... Reload the entire As-Built to the module... Do a load from ETIS and then write to module... should clear the DTC.

https://www.ucdsys.ru/forum/viewtopic.p ... ode#p16249

I also got the same problem, and some one told me to write the AB file to the IPC , but could not, it shows "Cant found any part numbers of IPC module in base! Check model of car selected!"

Btw, how can I attach the photo here for show the problem?

Need load configuration from ETIS in Direct Config IPC and use VIN