UCDS Forum

I have installed a mk4.5 (Facelift) Convers+ dash in my PreFL (mk4) Mondeo to replace the original PreFL Convers+ instrument panel.

I have applied the update through UCDS using the PreFL (2007>2010) update wizard, which has updated to BS7T-14C026-CG/BS7T-10849-XH - but this is not the most recent ROM as it still doesn't provide the latest features.

However, if i go through the FL update wizard (2011>2015) and load the module list from my car, the IPC has an update available to CS7T-14C026-CG/CS7T-10849-XH (which is the latest version). Would it be safe to update the dash with this version? Technically, the dash is from a FL, the car isn't

you cannot use standard fw for preFL or FL convers ... you need special fw for FL convers in preFL car
(standard FL convers in preFL car - airbag icon will be light)

Hello. I have convers+ FL . IPC BS7T-14C026-CE , Rom 1218 , I had updated to BS7T-14C026-CG, Rom 1304.
Question what names of files must be used to get Rom 1412 ? Possible update to rom 15xx ? If rom 15xx can be done so what files names must be used?

gsmunlock писал(а): 31 окт 2020, 19:00 what names of files must be used to get Rom 1412 ?

CS7T-14C026-CD
CS7T-14C026-ED

Bootload need flash as well? Bootloader will be good 7M2T-14C025-AA ? Or need different one?

I do not has ucds but I have original els27 v3.0 and using forscan.

yes, betta flashing works nice. I have flasher convers+ from 1218 --> 1304 , but forscan server does not offer higher firmware version
want to get minimum 1412 to get engine temperature on screen and clock too. I interesting in stock firmware only. I do not think it is big crime:) I am planning buy ucds with extended licence little bit later.

Today done my convers+ v1304 --> v1507 by stock firmware update / i have got what i wanted . Thank you everybody for help.

v1507 has different icons, use v 1412

Hi

Mondeo rom1302
which is the correct choice 1 or 2 in the picture
Thanks