IPC Error U2100

[silvercircle]

I have updated the IPC with the UpdateWizard, now I have the error code "DTC Error read - IPC
DTC Errors: 1

U2100 - Initial Configuration Not Complete
Ext.Status: 0A - Minimum Adaption Limit Not Reached. (DTC) Present at Time of Request.
00- Error status not found in base ....

The update went through without error messages.
If I try now on the old state back again comes the message that I must download the file GJ5T-14C016-BK. Unfortunately, this does not work because the file is missing.

What can I do now to get the error away?

I'm grateful for every tip.

Thomas

Here I attach a few screenshots.

[DanMc85]

I have updated the IPC with the UpdateWizard, now I have the error code "DTC Error read - IPC
DTC Errors: 1

U2100 - Initial Configuration Not Complete
Ext.Status: 0A - Minimum Adaption Limit Not Reached. (DTC) Present at Time of Request.
00- Error status not found in base ....

The update went through without error messages.
If I try now on the old state back again comes the message that I must download the file GJ5T-14C016-BK. Unfortunately, this does not work because the file is missing.

What can I do now to get the error away?

I'm grateful for every tip.

Thomas

Here I attach a few screenshots.

In Direct Config... Reload the entire As-Built to the module... Do a load from ETIS and then write to module... should clear the DTC.

[silvercircle]

This is the current state of the files causing the error

[silvercircle]

Thank you, it has worked fine, no errors and the modul answerd.

I have updated the IPC with the UpdateWizard, now I have the error code "DTC Error read - IPC
DTC Errors: 1

U2100 - Initial Configuration Not Complete
Ext.Status: 0A - Minimum Adaption Limit Not Reached. (DTC) Present at Time of Request.
00- Error status not found in base ....

The update went through without error messages.
If I try now on the old state back again comes the message that I must download the file GJ5T-14C016-BK. Unfortunately, this does not work because the file is missing.

What can I do now to get the error away?

I'm grateful for every tip.

Thomas

Here I attach a few screenshots.

In Direct Config... Reload the entire As-Built to the module... Do a load from ETIS and then write to module... should clear the DTC.

[calvinlu001]

https://www.ucdsys.ru/forum/viewtopic.p ... ode#p16249

I also got the same problem, and some one told me to write the AB file to the IPC , but could not, it shows "Cant found any part numbers of IPC module in base! Check model of car selected!"

Btw, how can I attach the photo here for show the problem?

[kroligoff]

Need load configuration from ETIS in Direct Config IPC and use VIN