Update request calibrations PCM for Ford Mondeo MK5.

[Diamondear]

Hi,
due to the replacement of the PCM, I ask the courtesy if you can load the new calibrations with the following data:

New PCM Module with part number:

Part number: RMDS71-12A650-XC
Strategy : FS7A-14C204-CVN
Hardware type: DS71-12B684-XB

Old PCM Module fail:

Part number: FS7A-12A650-CVK
Strategy : FS7A-14C204-CVL
Hardware type: DS71-12B684-XB

Thanks

[kroligoff]

module already programmed? CVN is newly

[Diamondear]

Hi kroligoff,

To be precise, the Ford workshop had to replace the PCM and then charged me with the new calibration.
The new PCM has however a new Part number "RMDS71-12A650-XC" which collects many calibrations for the Ford cars es. Focus, Kuga, S-Max, Mondeo and anyway 2.0D engines.
You should make sure that the new part-number is recognized by the UCDS Wizard Update.

The last calibrations for my Mondeo 2.0D is "FS7A-14C204-CVN"

Maybe you will not believe it, but Ford Italy is selling these PCM for €142,00 and I bought another one.

Thanks

[kroligoff]

Good day. Part number is OTP data. Its programs if new module is cleared, first flash current firmware set correct part number.
You buying module who have already firmware, and not correct part number?

[Diamondear]

The new module is delivered empty without any calibration. Then you need to install the desired calibration.

The code produced in Ford Ecat is: 2037011

[kroligoff]

One way, manually change in UUW file (save session file) with notepad, and change in PCM F113 on correct number, after open this files.

[Diamondear]

@ kroligoff

Big question:
As mentioned, I purchased another PCM of the same type and it is empty.
According to you, after replacing it to my Mondeo, installing the same calibration (with VBF Loader) and loading As-Built taken from the direct config of UCDS, could it work as a duplicate PCM?

Could I have problems with the other modules?

Thanks

[turbokiller]

bump:
short question:

how to find a 180 hp calibration for:

mondeo 2015
fwd
manual gearbox

i want to

is there a easy way to find out the calibration name
difference between 150 and 180 hp?
like cvn and ... ?

[phpixde]

There is no difference, both engines using the exact same software. The power-level can be switched in PCM.

[turbokiller]

fine,do you know where is the switch?
is it #23
engine pwr rate 3?
regards andreas